AGFA 2100 - Manual (Page 47)

2.8 Using Duplex Printing
The manual feed functionality of the DEClaser 2100 printer allows you
to do duplex (two-sided) printing.
Since the paper must pass through
the printer twice to perform two-sided printing, consider these additional
cautions when making duplex prints.
• Do not use transparencies, labels, or envelopes when making duplex
prints; use paper only.
• A curl in the leading edge of the paper may cause the paper to wrinkle,
misprint, or jam. Flatten out any curl on the paper before making a
duplex print. If the curl cannot be flattened completely, place the paper
so the curl faces up in the feeding direction, as shown below. The paper,
however, should not curl more than 5 mm (0.2").
Fig 2-22, MLO-004843
• If you have made numerous duplex prints, you should make several test
prints before continuing to use the printer (see Section 2.13). Running
the test prints removes any excess toner clinging to the fixing assembly
rollers.
Operating Information 2–21