AGFA 2100 - Manual (Page 81)

Table 3–2 (Cont.): Keypad Functions: Keypad Mode
Key Function
Form Feed Form Feed works in conjunction with the Data indicator. If
the Data indicator is on after a file stops printing, it means
there is still data in the print buffer. Pressing
Form Feed
prints the remaining pages in the print buffer.
When you press Form Feed , the indicator on the key lights
to show that the data is being printed. If you press
Form Feed again while the data is printing, it stops printing
the remaining pages and the indicator flashes until the
current page exits the printer. Once the page exits the
printer, the indicator light remains off.
Form Feed can be
pressed again to resume printing.
Error Skip The DEClaser 2100 printer alerts you to certain error
conditions by stopping the printer and displaying the type
of error on the control panel.
When this happens you
may elect to note the problem and then continue printing
by pressing
Error Skip . Pressing Error Skip bypasses these
errors so that printing continues. After you press Error Skip
the printer remains off line. You must press On Line to
place the printer back on line and continue printing.
Some errors can repeat, such as communications errors
or print formatting errors when the printer is receiving
additional communication data. When this happens you
may need to repeat the Error Skip procedure several times.
Refer to Chapter 6 for additional information about errors
and corrective actions.
Test/Font Test/Font performs several functions in Keypad Mode:
• Pressing the key once prints Test Print A (see
Section 2.12).
• Pressing and holding the key down for at least three
seconds prints Test Print B (see Section 2.13).
• Pressing the key twice prints the Font List (see
Section 2.14).
The Control Panel 3–5