AGFA 2100 - Manual (Page 75)

2.15 Using Control Representation Mode
The Control Representation Mode is used to print out unprocessed data
or commands sent from the host computer. This procedure is sometimes
referred to as ‘‘dumping.’’ The printing of unprocessed data (in the form
of characters and symbols) is convenient for debugging programs.
If a
specified character is undefined, a hexadecimal representation is printed
in its place.
This section explains how to print the character listing. For additional
information about Control Representation Mode, consult the Digital ANSI-
Compliant Printing Protocol Level 3 Programming Reference Manual.
NOTE: If the file does not fill the page buffer completely, the remaining
data can be printed by pressing On Line to place the printer off line, and then
pressing Form Feed to print the partial page.
2.15.1 Entering Control Representation Mode
Use the procedure in Table 2–6 to place the printer in the Control
Representation Mode.
Table 2–6: Entering Control Representation Mode
Operation Display Reads
1. Press On Line to place the
printer off line.
— The On Line indicator
shuts off.
00 READY
2. Press and hold
Reset for about
10 seconds.
03 RESET
#
03 DUMP
#
03 RESET
#
00 READY DUMP
The printer is now in the Control Representation Mode and ready to accept
data or commands from the printer. To exit the Control Representation
Mode, perform a soft reset (see Section 2.16).
Operating Information 2–49