AGFA 2100 - Manual (Page 95)

Table 4–6 (Cont.): Changing and Saving Values
Operation Display Reads
6. Press
/ until the
value equals -10.0.
NOTE: The value decreases
in steps of 0.5.
offsetX -10.0
7. Press
r
Enter to enter
the new value.
offsetX =-10.0 (momentarily)
#
offsetX offsetY
8. Press
. once to scroll
the display to the offsetY feature.
offsetY autoNL o
9. Press
r
Enter to select
the offsetY feature.
offsetY =+0.0
10. Press
/ until the
value equals -10.0.
NOTE: The value decreases
in steps of 0.5.
offsetX -10.0
11. Press
r
Enter to enter
the new value.
offsetY =-10.0 (momentarily)
#
offsetY autoNL o
12. Press
4 to return
to the menu selections.
LAYOUT COPY/OVER
13. Press
/ three
times to reach the
NVRAM SAVE menu.
SAVE->NVRAM LOAD
14. Press
r
Enter to save
the offset values in
NVRAM.
OK (momentarily)
#
SAVE–>NVRAM LOAD
Printer Configuration 4–13