HP StorageWorks XP Remote Web Console Software - Manual (Page 135)

SNMP Agent Operations
NOTE:
To set the SNMP Agent properties from the XP Remote Web Console, you must click the Extension
SNMP check box on the SNMP IP Security panel. You must have write permission to change the SNMP
Agent properties.
Adding SNMP Manager IP Addresses
To add SNMP Manager IP addresses:
1. Change to Modify mode.
2.
Click Install ( ).
3. Click the SNMP IP Security tab ( Figure 94 ).
4. Enter the desired numerical IP address in the IP Address text box ( Figure 95 ).
5. Click Set to add the new IP address. The new IP address is added to the IP Address list, but the
changes are not implemented until you click Apply.
6. To apply the changes to the array, click Apply. Click OK on the confirmation message.
Figure 95 Adding SNMP Manager IP Address (Left: Before Setting. Right: After Setting)
.
Deleting SNMP Manager IP Addresses
To delete a SNMP Manager IP address:
1. Change to Modify mode.
2.
Click Install ( ).
3. Click the SNMP IP Security tab.
4. Left-click one or more unwanted IP addresses in the IP Address list box to select them. Right-click
to display the Delete IP Address pop-up command (see
Figure 96 ).
XP Remote Web Console User Guide 135