The printer’s internal prints – HP Designjet T120 ePrinter User Manual
Page 19
To turn it back on, plug in the power cord.
When the printer is powered back on, it takes about three minutes to initialize and check and prepare
the printhead. Preparing the printhead takes about 75 seconds.
NOTE:
When the printer has not been used for a certain period of time (the default time is
determined by Energy Star), it saves power by going into sleep mode. However, any interaction with
the printer's front-panel display, or sending a new job to print, returns it to active mode, and it can
resume printing immediately. To change the sleep mode time, see
The printer’s internal prints
The internal prints give various kinds of information about your printer. They can be requested from the
front panel.
Before requesting any internal print, check that the printer and the paper are ready for printing. The
loaded paper should be at least A4 portrait—210 mm (8.27 in) wide—otherwise the print may be
clipped.
ENWW
The printer’s internal prints
11