HP Designjet T120 ePrinter - Manual (Page 43)

2. If your printer is a T520, open the roll cover.
3. Insert the spindle into the printer, holding it by both ends. The blue hub should be on the left, as
viewed from the front of the printer.
4. If the edge of the roll is not straight or torn (sometimes due to tape used to hold end of the roll),
pull the paper slightly and cut a straight edge.
5. Insert the edge of the paper into the printer.
WARNING! Do not push your fingers inside the printer's paper path.
ENWW Load a roll into the printer 35