HP Designjet T120 ePrinter - Manual (Page 36)

Configure network settings
You can view and configure the network settings from the Embedded Web Server, the HP Utility or the
front panel.
● From the Embedded Web Server: Select the Setup tab, then Networking.
● From the HP Utility: You can access the Embedded Web Server through the HP Utility.
● From the front panel: press , then Connectivity.
The following options are available:
● Enable/Disable wireless turns the wireless connection on or off.
● Wireless setup wizard provides an easy way to connect to a wireless network.
● Wi-Fi protected setup allows you to set up a connection with a wireless network using WPS
(pushbutton or pin) encryption.
● Network summary displays information about the wired or wireless network
● Print wireless network test runs diagnostic tests of wireless connectivity
● Print network configuration
● Advanced setup
◦ Select I/O timeout sets the time that the printer will wait for the driver to send a job to the
printer once the connection has been opened. Values range from half a minute to half an
hour.
◦ Link speed sets the speed at which data are transmitted over the network. The default is
Automatic.
◦ IP settings allows you to view or change the IP address, subnet mask, default gateway, and
DNS address.
◦ Hostname allows you to change the hostname.
● Restore network defaults
Configure firewall settings
Firewall features provide network-layer security on both IPv4 and IPv6 networks. The firewall provides
simple control of IP addresses that are allowed access.
NOTE: In addition to firewall protection at the network layer, the printer also supports open secure
sockets layer (SSL) standards at the transport layer for secure client-server applications, such as client-
server authentication or HTTPS Web browsing.
For firewall operation on the printer, you must configure a firewall policy to apply to specified IP traffic.
Firewall policy pages are accessed through the Embedded Web Server and displayed by your Web
browser. After a policy is configured, it is not activated until you click Apply in the Embedded Web
Server.
28 Chapter 4 Personalizing the printer ENWW