Front-panel error messages, 17 front-panel error messages – HP Designjet T120 ePrinter User Manual

Page 140

Advertising
background image

17 Front-panel error messages

Occasionally you may see one of the following messages appear on the front-panel display. If so,

please follow the advice in the Recommendation column.

If you see an error message that does not appear here, and you feel in doubt about the correct

response, or if the recommended action does not seem to solve the problem, contact HP Support. See

Contact HP Support on page 137

.

Table 17-1

Text messages

Message

Recommendation

[Color] cartridge has expired

Replace the cartridge. See

Replace an ink cartridge

on page 76

.

[Color] cartridge is low on ink

Ensure that you have a new cartridge of the same color
ready.

[Color] cartridge is very low on ink

Ensure that you have a new cartridge of the same color
ready.

Depleted cartridges must be replaced to resume printing

Replace the cartridges as needed. See

Replace an ink

cartridge on page 76

.

Ink system failure

Contact HP Support. See

Contact HP Support on page 137

.

Maintenance 1 advised

Contact HP Support. See

Contact HP Support on page 137

.

Maintenance 2 advised

Contact HP Support. See

Contact HP Support on page 137

.

Maintenance 3 advised

Contact HP Support. See

Contact HP Support on page 137

.

One or more cartridges appear to be missing or damaged

Insert cartridges of the correct color as needed. See

Replace

an ink cartridge on page 76

.

Paper jam

See

The roll has jammed on page 100

or

The multi-sheet tray

has jammed on page 101

.

Paper width is smaller than the minimum size supported by the
selected paper source. Load cancelled.

Remove the paper and load paper of the correct size.

Loaded paper is too wide. Manual unload required.

Remove the paper manually and load paper of the correct
size.

Paper too far from lateral load line. Please try again.

Remove and reload the paper.

Please manually unload roll paper and try again.

Rewind the roll manually.

Single sheet is loaded with too much skew. Press Eject to
unload paper.

Remove and reload the paper.

The current job has been cancelled because the roll is out of
paper. Load the roll and send the job again.

Load a new roll.

132

Chapter 17 Front-panel error messages

ENWW

Advertising
This manual is related to the following products: