Form feed with or without cutting – HP Designjet T120 ePrinter User Manual
Page 49
Form feed with or without cutting
If you go to the front panel and press , then Form feed and cut, the printer advances the paper
and makes a straight cut across the front edge. There are at least two possible reasons why you might
want to do this.
●
To trim the leading edge of the paper if it is damaged or not straight.
●
To feed and cut the paper when the automatic cutter has been disabled.
NOTE:
The printhead is serviced after each print, and the paper cannot be cut until the process
completes, so you may notice a delay.
CAUTION:
Remove the cut piece from the output platen. If strips or short prints are left on the output
platen, the printer could jam. Check also that there are no pieces of paper in the cutter guide.
NOTE:
Photo and coated paper requires careful handling, see
The print is scuffed or scratched
.
To advance the paper without cutting it, go to the front panel and press , then Form feed.
ENWW
Form feed with or without cutting
41