HP Storage Mirroring V4.5 Software - Manual (Page 126)

10 - 2
While there may be other Storage Mirroring connections between the selected source and target,
Application Manager only recognizes connections that it has created.
Any connection that has been built by Application Manager will be recognized as a valid connection,
regardless of the connection state.
Disable protection
You can disable an existing Application Manager-generated source/target connection monitor within
the Application Manager.
You must disable protection before you can change any of the Application Manager configuration
parameters.
1. If you select a source that is already protected in the Source Server field, the target server will
be filled in automatically and the Protection Status should indicated Protected.
2. Click Disable Protection at the bottom of the window, or select Actions, Disable Protection,
to disable protection.
Monitor protection status
After the initial mirror, your source server is protected.
To change whether failover monitoring is enabled, click the Enable/Disable Monitoring button at
the bottom of the window, or select either Enable Monitoring or Disable Monitoring from the
Actions menu.
Protection status states
The following table describes the possible protection status states.
SharePoint
BB_<source server>_<target server>
BlackBerry
SharePointdag01_<source server name>_<target server name>
NOTE: If you modify your configuration on the source server (such as adding a new storage
group or database to a directory that was not included in the replication set), you must
disable protection, run validation and fix any issues, then re-enable protection to apply
the changes to the Application Manager replication set.
NOTE: You cannot use both the Failover Control Center and the VMware interfaces to monitor a
source/target pair at the same time. Hewlett-Packard recommends that all monitoring
occur from the Application Manager interface. If both interfaces are open and a failover
condition occurs, failover will not be initiated until the failover prompt is cleared in both
interfaces.
Protection Status Description
Unprotected No Storage Mirroring connection exists
Warning Storage Mirroring connection exists, but has issues (such as
with target state, mirroring, or replication). For example, if the
mirror has been paused outside of the Application Manager or if
the target is down.
See details for more information.
Protected Storage Mirroring connection exists and is active
Synchronizing (% complete) Mirroring is in progress
Unknown Source server is not selected
Application Replication set name