HP xw4400 Workstation User Manual
Page 136
HP Remote Graphics 4.2.0 User's Guide
128
directory. At least two files appear in this directory for a single connected
device:
a. /proc/devices/usb_remote/devices - File contains a list of
recognized devices by the Receiver system.
b. /proc/devices/usb_remote/# - If only one USB device is recognized,
the "devices" file will have a single entry, 192. The file descriptor
named 192 is the Remote USB device. Dumping this file with 'cat
192
', for example, displays specific data about device 192. This should
reflect the connected USB device. If multiple devices are connected,
then each will have a file descriptor numbered consecutively starting
at 192.
7.
Directory Mode and Enterprise Service Mode:
If running in Directory Mode or Enterprise Service mode, the sender system
must be selected before connecting to any systems. If a different sender
system is required after connection, then all systems must be disconnected, a
new sender system selected in the Receiver Control Panel, and then all
senders can be reconnected.
8.
Reset the USB Device:
Press the reset button on the device if it has a reset button. If the device has
entered into a bad state, it may fail to connect. Pressing the reset may allow
the device to connect.