HP xw4400 Workstation - Manual (Page 150)

HP Remote Graphics 4.2.0 User's Guide
142
Setup Mode hotkey
sequence is invalid.
The sequence has
been reset to the
default. The Setup Mode hotkey sequence specified using a
property either on the command-line, property
configuration file, or RGS Enterprise Service, is
invalid and has been reset to the default.
Setup Mode hotkey
sequence is invalid.
The sequence has
been disabled. The Setup Mode hotkey sequence specified using a
property either on the command-line, property
configuration file, or RGS Enterprise Service, is
invalid and the property
Rgreceiver.Hotkeys.IsMutable is disabled. Therefore
hotkeys have been disabled.
Connection denied!
The iLO remote
console is enabled. The iLO remote console is enabled on the HP Blade
Workstation. The Blade must be configured in User
Mode before connections are allowed.
Unable to connect
to Sender:
The Receiver was
unable to resolve
the specified
hostname or IP
Address. Verify
that you entered
the value correctly.
This is usually indicative of a DNS error.
Unable to connect
to Sender:
The Receiver
resolved the
specified hostname
or IP address, but
cannot connect to
the Sender. Verify
that the system is
accessible on your
network and that
the Remote
Graphics Sender
service has been
started and is
listening on a pubic
IP address and is
not blocked by a
firewall.
The Receiver was able to lookup and resolve the
specified hostname or IP address. However, the
Receiver was unable to establish a connection to the
Sender. There are several possibilities such as the
Sender is not installed, the Sender is not running, the
Sender is listening on the wrong network interface, or
a firewall is blocking the Sender.