HP xw4400 Workstation User Manual
Page 35
Getting Started with Remote Graphics Software
27
The next volume control to adjust is the mixer line of the Recording Control. The
name of this line varies with different audio devices. See the Windows Sender Audio
Installation section for information on how to determine the name of this control. For
our example, the control is called Wave Out Mix. Adjust this volume control while
playing a sound. At higher levels, the audio signal gets clamped and the signal
becomes distorted. Decrease the level until the sound becomes clear. On some
devices, the mixer volume control does not go to zero. In this case, the Wave line of
the Volume Control will need reduction. The following image demonstrates the Wave
Out Mix level needed to eliminate distortion. Note that this is in the Recording
Control.
The best sound to play to calibrate your audio device is a low frequency sound with
high amplitude. By default, Windows assigns a program event that meets these
requirements. To play this sound, open up the Sound and Audio Devices control
panel and click on the Sounds tab as shown in the following windows.