HP Onboard Administrator - Manual (Page 14)

Accessing the command line interface 14
Pin Name Signal direction Description
4 DTR -->> Data terminal ready
5 GND System ground
6 DSR <<-- Data set ready
7 RTS -->> Request to send
8 CTS <<-- Clear to send
9 RI <<-- Ring indicator
2. Use any standard communication software to launch a terminal emulation session with the following
parameters:
Parameter Value
Transmission rate 9600 bps
Data bits
8
Parity None
Stop bits 1
Protocol None
3. When prompted, enter a valid user name, and then press Enter.
4. Enter a valid password, and press Enter. The CLI command prompt appears.
5. Enter commands for the Onboard Administrator.
6. To terminate the terminal session, enter Exit at the prompt.