HP Onboard Administrator - Manual (Page 190)

VLAN commands 190
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
The VLAN ID is a value between 1 and 4094.
SET VLAN FACTORY
• Command:
SET VLAN FACTORY
• Description:
Restores the VLAN settings to factory defaults. VLAN is disabled and all devices are grouped in VLAN
ID 1. To execute the command, enter YES when asked if you are sure you want to restore VLAN settings
to factory defaults.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
None
SET VLAN INTERCONNECT
• Command:
SET VLAN INTERCONNECT <VLAN_ID> { ALL | <bay number> [{ , | - } <bay number>]
}
• Description:
Sets the VLAN ID for the specified interconnect or range of interconnects.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
o You must create a VLAN ID using the ADD VLAN command, before using the SET VLAN
INTERCONNECT command, or the command is rejected.
o All Virtual Connects that belong to the same domain must be on the same VLAN.
SET VLAN IPCONFIG
• Command:
SET VLAN IPCONFIG { DHCP | STATIC | SAVE }
• Description:
Temporarily sets the OA VLAN ID and IP mode to DHCP or STATIC. The IP mode setting applies to the
specific OA, and the VLAN ID setting applies to both OAs. If a VLAN ID does not exist, it is created. This
command (typically used to test a new network setting) will undo its changes in 5 minutes. To
permanently save the changes, issue the SET VLAN IPCONFIG SAVE command.