Airstream 390 - Manual (Page 58)

G
PLUMBING
G - 12
MICROTECH™ FILTER INSTALLATION
NOTE: Faucet will not operate in any mode without fil-
ter. Filter should be left in protective bag until ready for
installation, The MicroTech™ filter is a high performance
carbon block filter developed specially for the PureTouch
Filtering Faucet System. Once the filter is installed in
the pullout spout, it should not be removed until it is
to be replaced. The electronic module keeps track
of the amount of filter life remaining and will signal
you when the filter change is necessary. If a partially
used filter is removed and reinstalled, the electronic
indicator will automatically reset and will not accu-
rately reflect filter life remaining.
Use only Microtech filter cartridges with the PureTouch
Filtering Faucet System.
1. Remove the filter cover by lifting it up and away from
the pullout spout body.
2. Insert the new filter by aligning the outlet tubes on the
filter with the inlet ports of the spout body and gently
pressing in and down. Upon successful installation
of the filter cartridge, the filter life indicator will beep
three times and reset automatically. (Do not remove
the filter until it is to be replaced.)
3. Re-install the filter cover by positioning the alignment
tab with the corresponding notch in the main pullout
spout body and gently pushing in and down.
4. Attach the pullout spout to the hose by aligning the
dots on the quarter turn connector (18) and the spout.
Push the quarter turn connector onto the spout
assembly and turn it clockwise, locking it in place.
5. Allow cold water to run through the new filter for
5 minutes to flush out any loose carbon particles.
Once these small black particles are washed out the
filter is ready for use.
The PureTouch System installation is now complete.
Please read carefully the operation instructions to en-
sure optimal performance.
CARE AND MAINTENANCE
All that is needed to clean your faucet is a soft damp
cloth. Moen does not recommend the use of scour
pads, cleansers or chemicals. The abrasive nature of
these substances could damage the faucet’s finish. A
nonabrasive car wax will help to protect the finish. DO
NOT PLACE WAND APPLIANCE IN A DISHWASHER.