Airstream 390 - Manual (Page 80)

H
ELECTRICAL SYSTEM
H - 8
MICROPULSE SYSTEMS MONITOR
OPERATION INSTRUCTIONS
This example shows the monitor report-
ing the following:
Fresh Water = 1/8 to Empty
Gray Water 1 = Empty to 5/8
Gray Water 2 = 3/4
Black Water = Empty to 5/8
LP Gas = 1/4
Battery = Empty to 5/8
On all diagrams the Letters R=Red,
Y=Yellow, G=Green, Blank=no LED lit.
NORMAL OPERATION
The MicroPulse Monitor will display the condition of each system at all times. The
tri-color LED beside the system will indicate the condition of the system using the
following color code.
Fresh Water, LP Gas, Battery are as follows:
Green LED = 3/8 to Full
Yellow LED = 1/4
Red LED = 1/8 to Empty
Gray Water, Black Water are as follows:
Green LED = Empty to 5/8
Yellow LED = 3/4
Red LED = 7/8 to Full
TO OBTAIN EXACT READING
To obtain an exact reading of all systems press and release the status button one
time. The monitor will flash the LED beside the system it is about to report. It will than
display the exact condition of that system by lighting the bar graph from Empty to Full.
The monitor will display the exact condition of each system and then return to normal
operation mode.
To obtain an exact reading of an individual system press and release the status button
until the LED beside the system that you want the condition of is lit. Release the status
button and the monitor will display the exact condition of that system by lighting the
bar graph from Empty