Airstream 390 - Manual (Page 81)

H
H - 9
ELECTRICAL SYSTEM
TV ANTENNA
Manufacturer:
Winegard Company
3000 Kirkwood Street
Burlington, Iowa 52601
Phone: 800-843-4741
Raising Antenna to Operating Position
Turn elevating crank in “UP” direction until some
resistance to turning is noted. Antenna is now in
operating position. Check to make sure switch on
front TV jack is on.
Rotating Antenna
Make sure antenna is in “UP” position. Pull down
on directional handle with both hands until it dis-
engages ceiling plate and rotate for best picture
and sound on television set.
Lowering Antenna to Travel Position
Rotate antenna until pointer on directional handle
aligns with pointer on ceiling plate.
WARNING : Antenna must be in
“down” position while traveling to prevent
damage.
Turn elevating crank in the “Down” direction until resistance is noted. Antenna is now
locked in travel position.
Checking Operation
1. Tune TV receiver to nearest station and rotate antenna for best picture and sound.
2. Turn off switch on power supply. Picture on TV receiver should be considerably
degraded with the power off.
DO’S
1. Do check parking location for obstructions before raising antenna.
2. Do carefully raise, lower and rotate - if difficult, check for cause.
3. Do rotate slowly when selecting station and check fine-tuning on TV set to make
sure it is properly adjusted.
4. Do lower antenna before moving vehicle.
DON’TS
1. Don’t force elevating crank up or down. Check for cause of trouble.
2. Don’t rotate directional handle hard against stops.
3. Don’t travel with lift in up position.
4. Don’t leave lift part way up or down.
5. Don’t apply sealing compound or paint over top of base plate or anywhere on lift.