HP XP Racks - Manual (Page 216)

TIP:
As of Replication Manager version 6.3, mainframe pair status information can be obtained using
Device Manager (without HP StorageWorks P9000 for Business Continuity Manager Software or
P9000 mainframe agent installed). Detailed pair state information for mainframe pairs in Device
Manager is equivalent to the information for open systems pairs shown in
Table 9 .
Legend:
--: Not applicable
Cnt Ac-S: Continuous Access Synchronous
Cnt Ac-A: Continuous Access Asynchronous
Cnt Ac-J: Continuous Access Journal
BC: Business Copy
1. If HP StorageWorks P9000 for Business Continuity Manager Software 5.0 is being used, the
status of the primary volume is
SUSPCU , and the status of the secondary volume is SWAPPING ,
the copy pair status is displayed as SUSPCU in HP StorageWorks P9000 for Business Continuity
Manager Software and Split (SW) in Replication Manager.
2. If HP StorageWorks P9000 for Business Continuity Manager Software 5.0 is being used, the
status of the primary volume is
SUSPER , and the status of the secondary volume is SWAPPING ,
the copy pair status is displayed as SUSPER in HP StorageWorks P9000 for Business Continuity
Manager Software and Split (SW) in Replication Manager.
3. If HP StorageWorks P9000 for Business Continuity Manager Software 5.0 is being used, the
status of the primary volume is
DUPLEX , and the status of the secondary volume is SWAPPING ,
the copy pair status is displayed as PENDING in HP StorageWorks P9000 for Business Continuity
Manager Software and Split (SW) in Replication Manager.
4. Suspending , Copying or Deleting (TRANS) is the actual status, but in Replication Manager
this is abbreviated as Suspending or Deleting (TRANS) .
Changing copy pair status
Replication Manager allows you to change the copy pair status in open systems and mainframe
systems. Pair status change operations may be necessary to resume copy operations after recovery
from an error or unexpected pair status changes.
NOTE:
The Change Pair Status Wizard also supports site recovery operations for open systems. See “ Advanced
pair operations and recovery scenarios ” on page 233 for more information.
Related topics
• About copy pair status , page 205
• About changing copy pair status , page 217
• Change pair status workflow , page 227
• Advanced pair operations and recovery scenarios , page 233
Managing pair life cycle 216