HP XP Racks - Manual (Page 115)

Related topics
• About the Add Command Devices Wizard , page 116
• Setting up command devices , page 114
• Editing command devices , page 310
• Deleting command devices , page 311
Storage system types and volume requirements (command devices)
Volumes that meet the requirements listed here are displayed as candidate volumes in Replication
Manager.
Storage system types and requirements for using volumes as command devices
XP24000/
XP20000/
HP P9500 XP12000/
XP10000/
SVS200
Requirement
Y Y Volume not a paired volume
Y Y Volume not an external volume
Y Y Volume not a virtual volume
Y Y Volume access attribute must be Read or Write
Y Y Volume not reserved for Auto LUN
Legend:
Y: This requirement applies.
Command device settings for virtual machines
The Replication Manager command device configuration function cannot be used to set a volume as
a command device if the volume has been allocated for a VMware virtual machine.
To set a command device for the virtual machine:
1. Use Remote Web Console to set the volume as a command device.
2. Use Remote Web Console to add the command device in (1) to a VMware host group and set
a path for the command device.
3. Perform VMware Raw Device Mapping, and then make sure that the command device in (1) is
recognized by the virtual machine.
NOTE:
To link Replication Manager with the Device Manager agent running on a VMware ESX 4.x or ESXi
4.x guest OS, make sure that the Device Manager Agent and the Device Manager are version 7.0.1
or later.
User Guide 115