HP ProLiant DL385p Gen8 Server - Manual (Page 72)

Hardware options installation 72
3. Extend the server from the rack (on page 23 ).
4. Remove the access panel (on page 25 ).
5. If you need to remove a blank from the primary PCIe riser cage, remove the PCIe riser cage (" Remove
the primary PCIe riser cage " on page 29 ).
6. If you need to remove a blank from the secondary PCIe riser cage, remove the secondary PCIe riser
cage (on page
30 ).
7. Remove the expansion slot blank.
To install the component, reverse the removal procedure.
Installing a half-length expansion board
1. Power down the server (on page 23 ).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack (on page 23 ).
4. Remove the access panel (on page 25 ).
5. Do one of the following:
o Remove the primary PCIe riser cage (on page 29 ).
o Remove the secondary PCIe riser cage (on page 30 ).
6. Remove the expansion slot blank (" Removing the expansion slot blanks " on page 71 ).