HP ProLiant DL385p Gen8 Server - Manual (Page 97)

Cabling 97
o Secure the secondary PCIe riser cage full-length expansion board retainer (on page 33 ).
17. Install the access panel (on page 25 ).
18. Install the server in the rack (" Installing the server into the rack " on page 40 ).
19. Remove any installed hard drives (" Removing a hot-plug SAS or SATA hard drive " on page 60 ).
20. Install a SATA hard drive (" Installing a hot-plug SAS or SATA hard drive " on page 59 ) in hard drive bay
5.
21. Install hard drive blanks in any empty hard drive bays.
22. Connect each power cord to the server.
23. Connect each power cord to the power source.
24. Power up the server (on page 23 ).
25. Use RBSU (" HP ROM-Based Setup Utility " on page 103 ) to disable the embedded HP Smart Array
P420i Controller, if necessary.
150W PCIe power cable option
CAUTION: To prevent damage to the server or expansion boards, power down the server and
remove all AC power cords before removing or installing the PCI expansion cage.
Connect the cable as indicated.