HP XP Racks - Manual (Page 123)

Table 30 Configuration file details
Disk configuration definition file
Description Item
prefix.DSK.SNnnnnn.dad-id
where:
Naming convention
nnnnn = storage system serial number
Business Continuity Manager creates this file when you
scan a device. This file stores the device configuration Purpose
information, and is required for all copy types and for each
site.
See scanning procedures in “Acquiring volume information
(preparations)” (page 125)
Creation procedure in the ISPF panel
Each combination of a device address domain and a
storage system Created for:
NOTE: Create a disk configuration definition files on one or more other sites using one of these methods:
• Acquire the device information from the other sites and transfer it to the primary site.
•
Acquire disk configuration definition files by performing remote scans on one or more sites, other than the primary
site.
Path set definition file
Description Item
prefix.PATH.path-set-id Naming convention
Business Continuity Manager creates this file when you
define a path set. Required by the Logical Path Control
function Purpose
See “Creating a path set” (page 591) . Creation procedure in the ISPF panel
Each path set Created for:
Route list definition file
Description Item
prefix.ROUTE.route-list-id Naming convention
This file stores the route list configuration. Required to use
the Remote DKC control function and Cnt-Ac Sconsistency
preservation function Purpose
See “Defining a route list” (page 606) . Creation procedure in the ISPF panel
Each route list Created for:
Command device definition file
Description Item
prefix.CDEV.dad-id Naming convention
Creating configuration files 123