HP XP Racks - Manual (Page 690)

Figure 143 Flow of backup operation using BCM Monitor
Example of creating the YKMONOPT file used for a backup operation
For this operation example, create the YKMONOPT file as follows:
#Options for BCM Monitor
#CYCLETIME parameter (in seconds)
# How often BCM Monitor will monitor the first active copy group.
# Default: 300
CYCLETIME=600
#WAITTIMEOUT parameter (in minutes)
# Specifies default timeout value for the WAITFOR action and
# any other YKEWAIT CLI commands.
# Default: 180
WAITTIMEOUT=60
#MSGLEVEL parameter
# Controls the level of messages output to SYSTSPRT and CONSOLE.
# Default: INFO,CONS
#ONACTIONERROR parameter
# Specifies what to do when a defined action fails.
# Default : SKIPONLY
ONACTIONERROR=SKIPONLY
Example of creating the YKMONCG file used for a backup operation
For this operation example, create the YKMONCG file as follows:
#Copy Group MYUR # First Copy Group definition
CGID=MYUR # Copy Group ID
CGPREFIX=BCM.DEMO # Prefix
CGDAD=DADP # Host DADID
CGROUTE=DEMORLST # Route list ID
CGMONSTAT=ACTIVE # MYUR will be monitored
CGSTARTUPSTATUS=DUPLEX,EXIT(32) # DUPLEX is expected as start status.
# If not, BCM Monitor will terminate.
690 Automatic operation using BCM Monitor