HP IMC Branch Intelligent Management Software - Manual (Page 26)

1. Select the Service tab, and click Resource > All CPEs in the BIMS navigation tree to display
the All CPEs list page.
2. Click a CPE name to display its information page.
3. Click Remote Reboot in the right configuration pane, and review the dialog box prompting
you to confirm or cancel the task.
4. Click OK.
Method 4
1.
Select the Service tab, and click Resource > All CPEs in the BIMS navigation tree to display
the All CPEs list page.
2. Click of a CPE group to enter its Subgroup/CPE list page. If there is a CPE on the page,
click the icon in the Operation column of the CPE, select Remote Reboot, and review the dialog
box prompting you to confirm or cancel the task.
3. Click OK.
Factory reset
Use this function to perform factory reset of a CPE. Use one of the methods below.
Method 1
1.
Select the Service tab, and click Resource > All CPEs in the BIMS navigation tree to display
the All CPEs list page.
2. Select the checkboxes of one or more CPE, click Factory Reset, and review the dialog box
prompting you to confirm or cancel the task.
3. Click OK.
Method 2
1.
Select the Service tab, and click Resource > All CPEs in the BIMS navigation tree to display
the All CPEs list page.
2. Click the icon in the Operation column of a CPE, select Factory Reset, and review the dialog
box prompting you to confirm or cancel the task.
3. Click OK.
Method 3
1.
Select the Service tab, and click Resource > All CPEs in the BIMS navigation tree to display
the All CPEs list page.
2. Click a CPE name to display its information page.
3. Click Factory Reset in the right configuration pane, and review the dialog box prompting you
to confirm or cancel the task.
4. Click OK.
Method 4
1.
Select the Service tab, and click Resource > All CPEs in the BIMS navigation tree to display
the All CPEs list page.
2. Click of a CPE group to enter its Subgroup/CPE list page. If there is a CPE on the page,
click the icon in the Operation column of the CPE, select Factory Reset, and review the dialog
box prompting you to confirm or cancel the task.
3. Click OK.
CPE additional information
Use this function to configure and manage CPE additional information. CPE addition information
refers to the information other than CPE basic information (such as CPE name, serial ID, CPE type,
OUI, vendor, and IP address). You can customize and manage the CPE addition information.
26 Resource management