Asus TW300-E5/PI4 - Manual (Page 114)

5-4 Chapter 5: RAID configuration
5.2 Marvel ® 88SE6145 RAID BIOS
Configuration Utility
The Marvell ® 88SE6145 RAID BIOS Configuration utility allows you to create
RAID 0, RAID 1, RAID 10, or RAID 5 set(s) from Serial ATA hard disk drives that
are connected to the Serial ATA connectors supported by the Southbridge.
To enter the Marvell
® RAID BIOS Configuration utility:
1. Install all the Serial ATA hard disk drives at Red SATA Connector.
2. Turn on the system.
3. During POST, press <Ctrl> + <M> to enter the utility main menu.
The RAID BIOS setup screens shown in this section are for reference only and
may not exactly match the items on your screen.
Marvell BIOS Setup (c) 2006 Marvell Technology, Ltd.
ENTER/SPACE:Select, ESC:Back/Exit
Adapter 1
Arrays Information:
No array is defined!
Disks Information:
ID Port Disk Name Size Speed Status
0 0 SATA: Hitachi HDS721010KLA330 1TB SATA II FREE
4 1 SATA: Hitachi HDS721010KLA330 1TB SATA II FREE
8 2 SATA: Hitachi HDS721010KLA330 1TB SATA II FREE
12 3 SATA: Hitachi HDS721010KLA330 1TB SATA II FREE
[ Adapter] [ Create] [ Delete]
4. Press <Enter> and select a desired adapter for RAID configuration.
Marvell BIOS Setup (c) 2006 Marvell Technology, Ltd.
ENTER/SPACE:Select, ESC:Back/Exit
Select Adapter
Adapter 2
[ Adapter] [ Create] [ Delete]
Adapter 1