Airstream PNEG-343 - Manual (Page 10)

10
DRYER CONTROL PANEL
when the moisture control is not used.
• Set the rate of grain discharge from
the dryer during the unload cycle of
staged batch dryer operation.
flow, pressing the dryer power start
button and then turning on the de-
sired dryer component.
HIGH SPEED METERING
ROLL POTENTIOMETER
The Airstream Dryer Control Panel mounted on the dryer.
DRYER POWER
START SWITCH
DRYER POWER
STOP SWITCH
This switch starts and operates the
dryer based on switch settings. If
other switch settings are in the off
position, individual dryer compo-
nents can be operated by turning the
drying mode switch to continuous
This switch stops all dryer func-
tions. If an automatic dryer shut-
down occurs, first determine and
correct the cause of the shutdown.
Then, press the dryer power stop
button to reset the dryer before
restarting.
This is used to:
• Set the high speed of the metering roll
when the two speed automatic mois-
ture control feature of the dryer is uti-
lized.
• Set the speed of the metering rolls
when the one speed automatic mois-
ture control feature of the dryer is uti-
lized.
• Set the speed of the metering rolls
during continuous flow operation