Airstream PNEG-343 - Manual (Page 11)

11
DRYER CONTROL PANEL
TURNING ON THE
ELECTRONIC
MONITORING CONTROL
SYSTEM
SETTING THE DRY, COOL,
BATCH AND UNLOAD
TIMERS
Turn the control power switch to on.
The monitor will display a copyright
message and model number, total
running time in hours and minutes and
the current time and date. To activate
the controller press the reset button.
if the dryer is stopped, these times
are saved by the controller. When
the dryer is restarted the timers will
continue timing down. The timers
will return to their initial setting if
the reset button is pushed.
SETTING THE OUT OF
GRAIN TIMER
If the dryer runs out of grain while the
load auger switch is in the auto posi-
tion, the out of grain timer automatically
shuts off the dryer after the period of time
preset on the timer. When pressed, the
display will show the amount of time left
on the timer and the percentage of time
used by the last load. A second screen
will appear with the timer's setting, and
may be modified as described in the
batch timer section.
The Electronic Monitoring Control
System (Figure 2) controls all tim-
ing functions and safety circuit
checks. It is designed to simplify
dryer operation by providing printed
messages and warnings on its liq-
uid crystal display (LCD).
ELECTRONIC
MONITORING CONTROL
SYSTEM
Figure 2: The Airstream Electronic Monitoring Control System
These switches are used to set the cycle
times in the staged batch drying mode
only. The drying mode switch must be
in the staged batch position. The cur-
rent setting on these three timers is dis-
played directly above each timer button.
To change the setting of these timers
follow these instructions:
1. Press the dry, cool or unload
timer button.
2. Press the modify button.
3. Press the increase or decrease
button to adjust the settings.
4. Press the enter button.
During operation the remaining
time on each timer is displayed on
the screen. If the power goes out or