EOTech MIPIM (AN/PEQ-16B) - Mini Integrated Pointer Illuminator Module - Manual (Page 28)

2-2
2.2 BATTERY HANDLING
Battery Inspection
Before installation, inspect the 3-volt lithium batteries for any
cracks, dents, leakage, or bulging. Never install a defective
battery in the MIPIM.
Battery Installation
WARNING
Ensure the Mode Selector is turned to the O (OFF)
position before attempting to install, remove, or
replace batteries.
WARNING
Do not store the MIPIM with batteries installed.
NOTE
Proper battery orientation is clearly marked on the
label near the battery compartment.
1. Unscrew the battery cap.
2. Tilt the MIPIM as shown in Figure 2-1 and install the first
DL123A lithium battery with the positive terminal facing in.
If necessary, gently shake the MIPIM to properly seat the
battery.
3. Install the second battery with the positive terminal facing
out.
4. Replace and tighten the battery cap.