Aiwa XC-RW700 - Manual (Page 11)

En
ENGLISH
11
PLAY DECK CONNECTIONS
OUTPUT JACKS:
A-1 ANALOG
Connect the ANALOG CD OUT jacks to the CD input
analog jacks on your receiver, preamp or surround
processor.
A-2 COAXIAL
Connect the COAXIAL CD OUT to the CD input coaxial
jack of your receiver, preamp, processor or external digital
decoder.
A-3 OPTICAL
Connect the OPTICAL CD DIGITAL OUT to the CD input
optical jack of your receiver, preamp, processor or external
digital decoder.
RECORD DECK CONNECTIONS
OUTPUT JACKS:
B-1 ANALOG
Connect the ANALOG CD-R/RW OUT jacks to the TAPE
play/in jacks on your receiver, preamp or surround
processor.
B-2 COAXIAL
Connect the COAXIAL CD-R/RW OUT jack to the coaxial
play/in jack on your receiver, preamp, processor or external
digital decoder.
B-3 OPTICAL
Connect the OPTICAL CD-R/RW DIGITAL OUT jack to
the optical play/in jack on your receiver, preamp, processor
or external digital decoder.
INPUT JACKS:
C-1 ANALOG
Connect the ANALOG CD-R/RW IN jacks to the TAPE rec/
out on your receiver or processor.
C-2 COAXIAL
Connect the COAXIAL CD-R/RW IN jack to the coaxial
rec/out jack on your receiver or processor.
C-3 OPTICAL
Connect the OPTICAL CD-R/RW DIGITAL IN jack to the
optical rec/out jack on your receiver or processor.
To make recordings from external digital sources
• If your receiver does not have digital output jacks, you
may connect the COAXIAL CD-R/RW IN / OPTICAL CD-
R/RW DIGITAL IN jacks on the unit directly to the coaxial/
optical rec/out jacks on your CD player or other digital
devices.
• If the CD player has both types of outputs, you may
connect one to the input of your receiver and the other
directly to the unit.
Using the DIGITAL IN (OPTICAL) jack on the front
panel
Connections to a portable digital CD or MD player may be
made by connecting the digital output of the player to the
front panel DIGITAL IN (OPTICAL) jack on this unit.
NOTE
Consult the owner's manual on your receiver or processor
for details, as the names of the jacks may vary from unit to
unit.
IMPORTANT NOTES ON DIGITAL CONNECTIONS
Coaxial Connections
• Use a commercially available digital cable (or 75-ohm
video cable).
• Do not use audio cords that are not appropriate for digital
signal use.
Optical Connections
• Use a commercially available optical fiber cable.
• To ensure proper connection of optical cable, fully insert
it into the jack until there is an audible click.
• Remember to save the plastic dust caps that cover the
optical jacks, and replace them when a jack is not in use
to prevent dust from entering the connection point.
POWER CONNECTIONS
Connect the AC Power Cord to an AC power source.
USING HEADPHONES
Connect headphones with a stereo standard plug (Ø 6.3
mm) to PHONES.
To adjust the volume, use PHONE LEVEL on the front
panel.
• Adjusting PHONE LEVEL will not alter the output settings
to the analog outputs. Those levels are fixed, and the
volume should be adjusted using your receiver, preamp
or processor.
• When the unit is in the dual playback mode (see page
23), only the output of the play deck will be fed to PHONES
jack.