Aiwa XC-RW700 - Manual (Page 5)

En
ENGLISH
5
CLEANING THE CABINET
Use a soft, dry cloth. If the surfaces are extremely dirty,
use a soft cloth lightly moistened with a mild detergent
solution. Do not use strong solvents, such as alcohol,
benzine or thinner, as these might damage the surface of
the unit.
STORING DISCS
After recording or playing, store the disc in its case.
Do not expose the disc to direct sunlight or sources of heat,
or leave it in a parked car exposed to direct sunlight, as
temperature may rise considerably inside the car.
CARE OF DISCS
• Discs can be scratched. Handle them carefully.
• When a disc becomes dirty, wipe it from the center out
with a soft cleaning cloth.
Do not use strong solvents such as alcohol, benzine,
thinner, commercially available cleaners or anti-static spray
intended for analog records.
REMOTE CONTROL
Inserting batteries
Detach the battery cover on the rear of the remote control
and insert two R6 (size AA) batteries.
Load the batteries as illustrated.
R6(size AA)
When to replace the batteries
The maximum operational distance between the remote
control and the sensor on the main unit should be
approximately 7 meters (23 feet). When this distance
decreases, replace the batteries with new ones.
Using the shared buttons
The remote control is designed to operate both of the CD
decks of the unit. Some buttons are dedicated to one
specific CD deck, while others are shared between the
two decks.
To use shared buttons, such as c , s , a , f , g , r ,
t , PRGM, PRGM CHECK, RANDOM, REPEAT, A B
and numbered, first press either CD/SEL to control the
play deck or CD-R/RW/SEL to control the record deck.
When CD/SEL or CD-R/RW/SEL is pressed, "CDP" or
"CDR" will appear on the appropriate information display
to confirm the selection.
NOTE
• If the remote control is not going to be used for an
extended period of time, remove the batteries to prevent
possible electrolyte leakage.
• The remote control may not operate correctly when:
- The line of sight between the remote control and the
remote sensor (located on the front panel) is exposed
to intense light, such as direct sunlight
- Other remote controls are used nearby (television, etc.)
PRGM
CD-R/RW/SEL
RANDOM
PRGM CHECK
REPEAT
c
CD/SEL
a
A B
0-9,+10
r , t
f , g
s