Avaya IP Office 15-601082 - Manual (Page 23)

AVPP Configuration
Wireless Installation and Configuration Guide Page 17
IP Office [15-601082] Issue [1] (1 June 2006)

Workgroup - as set in WINS.

Syslog Server - logging can be set to Syslog or NONE. If Syslog is set, a message is sent to the
Syslog server when an alarm is triggered.

Disable Telnet service - prevents Telnet access into the AVPP server. Reset the AVPP server
for the change to take effect. Upon reset the Telnet protocol server is not started.
The AVPP must be reset in order to set the configuration options. If the AVPP is in Maintenance Lock
and you press Esc, you will be prompted to reset the AVPP. At the reset prompt, press Y (Yes).
To manually reset AVPP, select Reset in the SVP-II Configuration screen and then press Y (Yes).
Send All
In an IP system with multiple AVPPs, the SendAll option is provided to speed configuration and ensure
identical settings. The S=SendAll option allows you to send that configuration parameter to every AVPP
on the LAN.
SendAll can only be used after the IP address is established on each AVPP via the serial connection. If
you anticipate identical settings across the LAN, set the IP address and custom hostname (if desired) for
each AVPP using the initial serial connection. Connect via the LAN and use SendAll to set identical
configuration options for all AVPPs.
If SendAll is to be utilized in your system, all passwords must be identical.
Warning

Do not change the password at the initial configuration if SendAll is desired.
Use the default password and change it globally, if desired, after a LAN connection is established for all
AVPPs.
If independent administration of each AVPP is desired, the passwords may be set at initial configuration.
Note

The IP address of the master AVPP can be changed in this menu. After rebooting the system,
you can change alias IP addresses in each of the other AVPP servers without error.