Avaya IP Office 15-601082 - Manual (Page 68)

Wireless Installation and Configuration Guide
Wireless Installation and Configuration Guide Page 62
IP Office [15-601082] Issue [1] (1 June 2006)
Wireless Phone Status Messages
Wireless phone status messages provide information about the wireless phone's communication with the
access point and host phone system. The following table summarizes the status messages, in
alphabetical order.
Message Description Action
3 chirps The wireless phone is not able
to communicate with the best
access point, probably
because that access point has
no bandwidth available. None. This is only a warning, the
call will handoff to the best access
point once it becomes available.
ASSERTxxx.c
Line yyy The wireless phone has
detected a fault from which it
cannot recover. Record the error code so it can be
reported. Turn the wireless phone
off then on again. If error persists,
try registering a different wireless
phone to the phone port. If error
still persists, contact Technical
Support and repeat the error.
Bad Config Some needed configuration
parameter has not been set. Check all required wireless phone
configuration parameters for valid
settings.
Bad ESSID The wireless phone is
configured for
“
static ESSID
”
(as opposed to
“
Learn once
”
or
“
Learn always
”
and no ESS
ID has been entered.
Enter an ESSID in the
configuration settings or change to
one of the "Learn
”
modes.
Charging... The wireless phone is
charging in the desktop
charger. No action needed.
Charge Complete The wireless phone is now
fully charged. No action needed.
Checking Code The wireless phone is
contacting the TFTP Server to
determine if it has a newer
version of software that should
be downloaded. None, this message should only
last for approximately one second.
If message remains displayed,
power off and contact customer
support for a replacement phone.
Checking DHCP IP The wireless phone is
retrieving DHCP information
from the DHCP server. None. This is information only.
CRC Code Error The software which has been
TFTP downloaded has a bad
redundancy code check. Try the download again, it is
possible the software was
corrupted during download. If the
error repeats, check that the
download image on the TFTP
server is not corrupted.
Code Mismatch! The software loaded into the
wireless phone is incorrect for
this model phone Replace the software image on
the TFTP server with software that
is correct for the phone model.