Airlink Raven GPRS - Manual (Page 20)

Raven Activation
12 Cingular GPRS Raven User Guide Version 2.01
Configuring the Raven using AT Commands
An alternate method to configure and activate your Raven is by AT commands (full
listing beginning on page 61) sent directly to the modem via a terminal application
(page 58). This method is recommended only in situations where the Setup Wizard
is not available and/or the configuration for the Raven is unusual.You can also con-
figure your modem using Wireless ACE (page 15) or AceNet (page 16) using a
template built in Wireless ACE. It is not recommended to activate a modem using
either Wireless ACE or AceNet.
Raven Indicator Lights
When your Raven is connected to power and an antenna, there is a specific pattern
to the lights to indicate its operation mode.
FIGURE 2. Raven indicator lights
Tx (transmit) and Rx (receive) - Lights will flash as data is transferred to and
from the modem on the network.
RSSI - Light shows the strength of the signal and may be solid (strong) or flash-
ing (weaker).
Reg - Indicates the modem is registered (activated) on the cellular network.
Chan and Link - Indicate a connection to the cellular network.
Pwr - Indicates the power adapter is connected and there is power getting to the
modem.