Airlink Raven GPRS - Manual (Page 83)

Cingular GPRS Raven User Guide Version 2.01 75
AT Commands
PassThru Mode is used to communicate directly to the Raven’s internal hardware
(OEM module).
*UDPLAST=n
n=0
n=1
If enabled, sets S53 to the last accepted IP address
through UDP auto answer. This can be used in conjunc-
tion with MD3 so that when there is no UDP session,
new ethernet host data will cause a connection to be
restored to the last IP accepted through UDP auto
answer.
Does not change S53 setting. (Default).
Set S53 to the last accepted IP.
Note: This does not change the S53 setting in NVRAM.
If the modem is reset, the original S53 setting will be
restored from NVRAM.
*USD=n
n=0
n=1-255
Waits the specified delay before sending the first UDP
packet and the subsequent UDP packets out to the Ether-
net port.
No UDP packet delay (Default).
Delay in 100ms units, from 100 ms to 25.5 sec.
\Qn
n=0
n=2
n=4
Set or query the serial port flow control setting.
No flow control is being used
RTS/CTS hardware flow control is being used
Transparent software flow control. Uses escaped XON
and XOFF for flow control. XON and XOFF characters
in data stream are escaped with the @ character (0x40).
@ in data is sent as @@.
\APPP none Set modem operation to PPP mode.
\ASLIP none Set modem operation to SLIP mode. DTR must be
asserted (&D0 or S211=1)
TABLE 5. Local Network and Host Modes
Command Parameters Details