Airlink Raven GPRS - Manual (Page 98)

AT Commands
90 Cingular GPRS Raven User Guide Version 2.01
TABLE 17. SNMP
Command Parameters Details
\ACEPW=pw pw=password Change the ACE password to a new value. Password is
case-sensitive. Default password is 12345.
Ex. AT\ACEPAW=new123
*SNMPPORT=n
n=0
n=1-65535
This controls which port the SNMP Agent listens on.
SNMP is disabled.
Port for SNMP agent to listen on
*SNMPSECLVL=n
n=0
n=1
n=2
Selects the security level requirements for SNMP com-
munications as follows:
No security required. SNMPv2c and SNMPv3 commu-
nications are allowed.
Authentication equivalent to 'authNoPriv' setting in
SNMPv3. SNMPv3 is required to do authentication,
SNMPv2c transmissions will be silently discarded.
Authentication and encryption, equivalent to 'authPriv'
setting in SNMPv3. SNMPv3 is required to do authenti-
cation and encryption, SNMPv2c and SNMPv3 authNo-
Priv transmissions will be silently discarded. Messages
are both authenticated and encrypted to prevent a hacker
from viewing its contents.
*SNMPTRAPDEST=[host]/
[port] host=IP address
port=TCP port
Controls destination for SNMP Trap messages.
If port is 0 or host is empty, traps are disabled.
Traps are sent out according to the SNMP security level
(i.e. if the security level is 2, traps will be authenticated
and encrypted). Currently, the only trap that can be gen-
erated is linkup.
TABLE 18. Other Settings
Command Parameters Details
*NUMTOIP=n
n=0
n=1
Convert 12 digit number to IP.
Use as name.
Use as IP.
\ACEPW=pw pw=password Change the ACE password to a new value. Password is
case-sensitive. Default password is 12345.
Ex. AT\ACEPAW=new123