Andrew OMACS3000 - Manual (Page 39)

11-APR-06 Rev E OMACS3000
39 of 51 System Screens
Figure 29: Working Satellite Table Screen
Satellite Entry Edit
If the operator chooses to edit a working table entry, the Satellite Table Edit Screen will pop up (see
Figure
30 ). He can then modify any or all parameters in the satellite table entry as listed. These parameters may be
typed in or copied and pasted from another screen. The cut and paste capabilities are dependent on using
Ctrl-C and Ctrl-V edit controls rather than mouse controls.
To save any changes, the operator must select OK. The corrected entry will be updated in the satellite table
and the corrected satellite table will be written to disk.