Vaisala CCL100 - Manual (Page 16)

User’s Guide _______________________________________________________________________
16 ___________________________________________________________________ M211490EN-A
CHAPTER 3
OPERATION
This chapter contains information that is needed to operate this product.
Activating the CCL100 Cold Chain Logger
To activate the logger, press the “Start/Mark” button located in the lower
left hand corner of the logger for a minimum of 2 seconds. The Logger’s
LEDs will flash to indicate successful activation in a rotating sequence
towards the “Start/Mark” button. The rotation sequence will occur 5
times.
Using the glue dot on the back of the logger, apply logger to the provided
“Find It” sign and attach. Alternatively, apply logger directly to product
packaging. LEDs will flash every four seconds to indicate active
monitoring.
Marking Events
After the logger has been started, users can indicate significant events,
such as product changing hands, by pressing the “Start/Mark” button.
To mark an event, hold down the “Start/Mark” button for a minimum of
1 second. The green LED will flash in slow flashes, increasing in speed,
to indicate an event has been successfully marked. Up to 5 marked events
will display on the PDF file. Note that a mark will not appear on the
graph if the “Start/Mark” button is pressed during the start delay period.
Marked events will not appear if the “Start/Mark” button is pressed while
the device is plugged into the USB port.
Stopping the CCL100 Cold Chain Logger
Loggers include a stop button by default. To stop active time and
temperature recording, press and hold the “Stop” button located in the
lower right corner of the logger for 3 seconds. The LEDs will flash in a
rotating sequence towards the stop button 7 times, followed by all LEDs
being illuminated then extinguished to indicate a successful stop. A
“marked” event will appear in the PDF at the stopped time.