Bondioli&Pavesi 399CECN02_G - Manual (Page 10)

10
ENG
SAFETY LABELS
SHIELD TUBE LABEL Code 399141000
SHIELD TUBE LABEL Code 399JAP001
The operator must obey all labels and must maintain the proper shielding. A large
percentage of accidents caused by PTO drive shafts occur when the shielding is
not present or is not functioning correctly.
DRIVE TUBE LABEL Code 399143000 - DANGER!
Keep clear of the work area and rotating parts.
Do not wear loose clothing, jewelry, or hair that could become entangled with the
driveline.
Contact with rotating parts can cause serious injury or death.
GUARD MISSING, DO NOT OPERATE.
Do not operate without all driveline, tractor and implement shields in place.
Damaged or missing parts must be repaired or replaced before using the
driveline.
SHIELD TUBE LABEL Code 399CECN01
SHIELD TUBE LABEL Code 399FXCN01
Rotating driveline – contact can cause death. Keep away. Do not wear loose
clothing, jewelry, or hair that could become entangled with the driveline.
Do not operate without all driveline, tractor and implement shields in place.
Damaged or missing parts must be replaced and installed correctly before using
the driveline. Disconnect PTO clutch, shut off tractor engine, and remove key
before approaching the implement. Keep all bystanders away from the implement
while in operation. Read this manual, and the operator’s manual for the implement,
before using the machine.
YOUR SAFETY DEPENDS UPON THIS INFORMATION.
SAFETY AND WORKING CONDITIONS
When using the implement and the driveline, do not exceed the speed
or power limits specified in the operator’s manual. Do not overload the
implement or suddenly engage the PTO clutch. Any torque limiter or clutch must
be installed on the implement end of the driveline. Use the implement only with
the original driveline, which is fit for the purpose in terms of length, dimensions,
devices and shields.
The driveline and its torque limiter or overrunning clutch are designed specifically
for the implement, and should be used exclusively for this purpose. Check the
implement instruction handbook to ascertain whether the driveline must be
equipped with a torque limiting or overrunning clutch. Standard drivelines, torque
limiters and overrunning clutches are designed for speeds of up to 1000 min –1 .
Ensure that the driveline can perform all operations without interfering with the
tractor or the machine. Contact with parts of the tractor, hooks, drive pins, tires,
drawbar, hammerstrap, or 3-point hitch, will damage the guard. Never use tractors,
(or systems for connection to the implement) that interfere with the driveline du-
ring operation. Do not use adapters or components not offered by the implement
manufacturer.
1
2
3
ENGLISH
4
TRANSLATION OF THE
ORIGINAL INSTRUCTIONS