Summers Disk-Chisel - Manual (Page 22)

CENTER W-TRANSPORT 3/11/2009 9CC3612-2008/
B
C
8K9650
8K1683
8X0285
1 1/2" N
8K9106
8D9108
1/4 X 2" RP
8T4300
8X0402
8X0432
CLVS PIN
8X0260
3/4" N
8X0306
3/4" LW
8R6914
8T3640
8X0044
7/16" X 3-1/2"
8T4100
8T4140
8X0306
3/4" LW
8X0260
3/4" N
8X0044
7/16" X 3-1/2"
8X0234
7/16" LNUT
8T3620
8T4166
8A1156
3/8 X 4-1/16 X 5"
8T4190
8X0203
3/8" FN
8K1100
8X0099
5/8" X 6-3/4"
8H2100
8T4100
8X0304
5/8" LW
8T4130
8K5515
3/4 X 4 X 6" 8T3620
8T3640
8X0044
7/16" X 3-1/2"
8X0234
7/16" LNUT
8T4132
8X0044
7/16" X 3-1/2"
8X0250
5/8" N
8K5515
3/4 X 4 X 6"
8K9106
8D9108
1/4 X 2" RP
8T1055
8K9106
8D9108
1/4 X 2" RP
8K1105
8K7033
8X0072
8X0242
SECTION 2 – SET-UP OF DISK-CHISEL & COULTER-CHISEL CENTER SECTION (32’-36’)
2-10
9. Install 8K1100 axle and hub assembly into each rear walking tandem. Install 8K1105S on front
center. Apply good quality anti-seize to axles before installation. Retain axle into receiver tube
with 1/2 x 3-3/4” bolt and locknut.
10. Attach wheels onto hubs with 9/16” wheel bolts (torque required: 122 ft-lbs) or 5/8” wheel nuts
(170 ft-lbs.).
11. Attach wing transport locks to center frame with 3/4” u-bolts.
– Located outside edge of bolt plate 78-3/8” away from frame center.
– Install 1/2 x 6” pins in inside storage holes of transport lock.
12. Insert 1-1/2 x 10-3/8” eyebolts into wing lift cylinder attach base.
– Leave 1-1/2” nuts loose, they will need to be adjusted after wing is installed.
13. Attach wing lift cylinders to frame with pins and roll pins.
– 32’ machine uses 4 x 36” cylinders (8K9640).
– 36’ machine uses 5 x 36” cylinders (8K9650).