Summers Disk-Chisel - Manual (Page 24)

WING 3/12/2009 9CC3612-2008.iam/
8T3600
8X0234
7/16" LNUT
8X0044
7/16" X 3-1/2"
8C6015
8CC4050-2008 8K5515
3/4 X 4 X 6"
8T4224
8X0285
1 1/2" N
8K1683
8X0260
3/4" N
8X0306
3/4" LW
T
2-12
SECTION 2 – SET-UP OF 32’ AND 36’ WINGS
NOTE: It is recommended to set up both sides of machine at the same time. The left hand side is
shown.
1. Attach wing to center section with pins, washers, bolts and locknuts.
– Washers are used to center wing in hinges and prevent shift.
2. Fasten cylinder attach brackets with 3/4” u-bolts, located 169” from machine center.
3. Insert eyebolts (8K1683) into cylinder attach bracket.
– Tighten 1-1/2” nuts so the same amount of threads are above top nut on all eyebolts. Insure
that cylinder attach holes are aligned when eyebolts are tightened.
4. Center liftarm under cylinder attach brackets.
– Use 3/4” u-bolts for 4x4 to attach liftarm pivots (8T4100) to frame.
– The inside pivot will be attached with 3/4 x 6” bolts and a trip assembly.
– Slide pivot pin (8T3640) through liftarm and liftarm pivots.