Summers Disk-Chisel - Manual (Page 32)

CENTER W-TRANSPORT 3/12/2009 9CC4012-2008.iam/
B
8K9650
8X0260
3/4" N
8X0306
3/4" LW
8K9106
8D9108
1/4 X 2" RP
8T4300
8K5515
3/4 X 4 X 6"
8K5515
3/4 X 4 X 6"
8T4100
8T4130
8X0099
5/8" X 6-3/4"
8X0304
5/8" LW
8X0234
7/16" LNUT
8T3640
8K7042
8K1105S
8X0242
NY-LOCK 1/2" N
8X0072
1/2" X 3-3/4"
8T4132
8X0044
7/16" X 3-1/2"
8X0250
5/8" N
8X0044
7/16" X 3-1/2"
8H2100
8T4166
8X0072
1/2" X 3-3/4"
8A1156
3/8 X 4-1/16 X 5"
8T4140
8X0203
3/8" FN
8X0234
7/16" LNUT
8T3620
8K7037
8K1105S
8X0044
7/16" X 3-1/2"
8T4190
8X0242
NY-LOCK 1/2" N
8X0260
3/4" N
8X0306
3/4" LW
8T3640
8X0234
7/16" LNUT
8X0044
7/16" X 3-1/2"
8T4100
8K5515
3/4 X 4 X 6"
8K9106
8D9108
1/4 X 2" RP
8T1055
8T1040
SECTION 2 – SET-UP OF CENTER SECTION 40’
2-20
– The front center lift arm (8T4130) has two cylinder attach locations. Use front cylinder attach
hole. Cylinder attach location can be changed based on fi nal adjustments. Connecting front
center cylinder to rear hole will lower front end of coulter-chisel in transport position.
9. Install 8K1105S axle and hub assembly into each walking tandem. Apply good quality anti-seize
to axles before installation. Retain axle into receiver tube with 1/2 x 3-3/4” bolt and locknut.
10. Attach wheels onto hubs with 5/8” wheel nuts (170 ft-lbs.).
11. Attach wing transport locks to center frame with 3/4” u-bolts.
– Located outside edge of bolt plate 78-3/8” away from frame center.
– Install 1/2 x 6” pins in inside storage holes of transport lock.
12. Insert 1-1/2 x 10-3/8” eyebolts into wing lift cylinder attach base.
– Leave 1-1/2” nuts loose, they will need to be adjusted after wing is installed.
13. Attach wing lift cylinders to frame with pins and roll pins.
– 40’ machines use 5 x 36” cylinders (8K9650).