Summers Disk-Chisel - Manual (Page 52)

GANG-SCRAPERS 8/28/2007 9CC3612.iam/
8J0190
8K4200
8K4210
8CC1000
8T4100
8CC1020
8J3246 - 46"
8J3256 - 56"
8J3266 - 66"
8J3276 - 76"
8J3286 - 86"
8CC1152
8K3002
8K4420
2-40
SECTION 2 – INSTALLATION OF SHANKS AND COULTER GANGS
1. Gang Mounting – Start from the center and work towards the outside when hanging the gangs.
Bearing location is important, use correct gang assembly for each location. Carefully lift gang to
frame close to correct location. Attach C-shanks to frame using (2) 3/4” U-bolts, mounting plate
with peg, fl at mounting plate, lockwashers and nuts. After both C- shanks on each gang are
mounted, slide the gang to its proper location and tighten hardware.
2. Scraper Mounting – Attach scraper mounting tubes to scraper support brackets (8J0200) using
3/4” U-bolts (8K5505), spacer fl at (8K4420), lockwashers and nuts. Attach scraper fl ats (8J0190)
to the mounting tubes using 3/4” U-bolts (8K5505), fl atwashers (lower hole only), lockwashers
and nuts. Center between coulter blades.