Summers Disk-Chisel - Manual (Page 40)

2-28
SECTION 2 – HYDRAULIC SET-UP (32’-40’)
1. Hydraulic hoses and fi ttings for depth control cylinders can be found on following drawing.
– Rephasing cylinders require that oil from the rod end of fi rst cylinder goes to base end of
second cylinder and so forth. Cylinders will not operate properly unless they are connected
correctly.
2. Special attention should be paid to routing of hydraulic hoses. Diagrahm below shows layout of
hoses for depth control cylinders.
A. It is best to start by routing the hose for the 6 x 10” cylinder. Make sure there is 60” of hose
ahead of hose holder. This is usually enough hose for safe and easy hook-up to tractor.
B. Route hose along hitch frame. Use plastic clamps provided. Do not tighten until routing is
complete.
– Clamps are made to have the round surface point towards the surface that you are
mounting to. DO NOT OVER TIGHTEN.
C. Leave slack by hitch pivot.