Electrix Tweaker - Manual (Page 6)

1. Getting Started
6
The TWEAKER enclosure was designed to keep overlays in place with minimal movement during
performances.
1.6 Firmware & Utilities
The TWEAKER’s firmware updates via USB. Firmware updates may become available from time to
time. Visit www.electrixpro.com to register your product and sign up to receive TWEAKER updates.
1.6.1 Checking Current Firmware Version
You can check your current firmware version at any time by holding the three buttons down
indicated on the image below, simultaneously:
While these three buttons are held down, the firmware version will be indicated on the bottom
encoder LED rings on both mixer channels. The left LED ring indicates the number before the
decimal point, and the right LED ring indicates the number after the decimal point. For example,
to indicate version 4.3, four LED’s will light up on the left ring, and three LED’s will light up on the
right ring.