Electrix Tweaker - Manual (Page 7)

1. Getting Started
7
1.6.2 Updating Firmware
1. Hold down the round rubber button located in the center of the four directional navigation
buttons, while connecting Tweaker to your computer,
2. A volume named TweakerDisk will mount on your system,
3. Drag the Tweaker firmware binary file and drop it onto the TweakerDisk volume,
4. The velocity pads will flash while the firmware is updating. Do not disconnect the USB cable
during this process,
5. It is safe to disconnect the USB once the pads have stopped flashing. Once the update is
complete you must reconnect the TWEAKER to return to normal operating mode.
1.6.3 LED Test
To test the LED’s, hold down button the large navigation encoder push button while connecting
Tweaker to your computer. All LED’s will light up. Press it again to exit and return to normal operating
mode.