Town One to Six chamber Ranges - Manual (Page 12)

5) How to Change The Pilot Light in a chamber with a Ring Burner or
Shield Tip Burner:
Shut off pilot valve. The pilot light is mounted on flexible tubing
and can be raised. Using a 12 mm open-ended wrench, hold the
center of the compression fitting below the pilot firm. Using a 1/2"
wrench, unscrew the pilot from its brass fitting at bottom. Install the
new pilot by reversing the above procedure. Adjust the pilot flame
at the pilot valve and be sure to check for gas leaks using a soapy
solution.
Jet burner: Shut off pilot valve. Using a 12mm open-ended wrench,
unscrew the pilot, remove and replace. If a 12mm open-ended wrench
is unavailable, a 1/2" open end or adjustable wrench may suffice.
12
6) Flue Collar Replacement ("F" models)
The cast iron flue collar may deteriorate after considerable use. If you
notice such deterioration, we suggest you contact your local service
company for replacement parts and qualified service. If you must replace
the flue collar yourself, follow the instructions below:
NOTE: Shut off gas to range. The burner and pilot must be removed
prior to removing the flue collar.
Remove old nuts behind range that secure flue collar (1). Remove
worn collars with pry bar (2). Put new collar into place using provided
hardware. Re-cement chamber (see page 11) and replace burner and
pilot.
pilot
MAINTENANCE AND CARE
1) If your equipment requires service, contact your authorized gas service company to perform neces-
sary repairs.
2) Check the flue riser monthly to be sure it is free of obstructions. Be sure to clean the air mixers and
orifices of ring burners once a year. Jet and shield tip burners must be serviced more often as they
become clogged more easily. This service must be performed by your local qualified gas service
company.
3) Your range should be cleaned each evening with grease dissolver and rinsed well. It will prevent
grease accumulation and keep the unit clean and sanitary.
4) If your unit is supplied with casters, there should be a restraint on the appliance to limit its movement.
If disconnection of the restraint becomes necessary, you must be sure to reconnect the restraint after
the appliance is returned to its originally installed position.
The following service should be done only by a qualified gas service technician.
3
OFF position:
turn clockwise
until screw can-
not be turned
further
ON position turn
counter-clockwise
PILOT
VALVE
1
2
FOOD SERVICE EQUIPMENT CO., INC. • 72 BEADEL ST • BKLYN • NY 11222