Town One to Six chamber Ranges - Manual (Page 8)

8
figure 1
figure 2
figure 3
7. Be certain that the range with an extension on
its gutter overlaps the gutter of the adjoining
range as shown in figure 4.
6. Insert the tongue into the groove and slide the
ranges together as shown in figure 3.
4. Carefully move the ranges to their final loca-
tion. Position the ends to be joined next to
each other. The battery was assembled at the
factory to assure good fit. Pitched floors will
add difficulty to battery assembly.
5. Generously apply silicon to the groove below
the stainless steel deck. Apply additional sili-
con to the tongue of the other range that will fit
into this groove. Figure 2 shows the groove.
1. Uncrate the ranges and place them on pallet
jacks. Be careful to position jacks away from
drip pan guides.
2. Install the legs onto each range. Secure legs
with the set screw in the gusset.
3. Remove the front body panels and serving
shelves from both ranges. Figure 1 shows a
detail of front right corner of a range with the
body front panel removed.
Splice Field Joint Installation Instructions:
Range decks have a "tongue and groove" so there is no standing seam between range decks. The decks
and backsplashes are joined. The gutters are separate but interlock.
figure 4
FOOD SERVICE EQUIPMENT CO., INC. • 72 BEADEL ST • BKLYN • NY 11222