Aalborg PWE Digital - Manual (Page 37)

32
The listed units in the table above can be set with the Up and Dn buttons and are
accepted by pressing ENT button.
4.3.1 User Defined Measuring Unit
This function enables user defined configuration of any engineering unit in the
converter. The following three parameters are available for this function:
a) Unit volume factor (defined in Liters)
b) Unit time base (defined in Seconds)
c) Unit with or without density support.
4.3.1.a User Defined Unit Factor Numeric entry
This parameter indicates the factor of the new unit with respect to one liter. The
default entry is 1.00 Liter.
4.3.1.b User Defined Unit Time Base Tabular entry
This parameter indicates the time base for User Defined Unit. The following selec-
tions are available: 1 second, 60 seconds (1 minute), 3600 seconds (1 Hour). The
default entry is 60 seconds.
The listed time based selections above can be set with the Up and Dn buttons and
are accepted by pressing ENT button.
Note: The entry of the listed parameters a), b) and c) is only
necessary in case the required engineering unit is not available in the
table above, (see Section 4.3).
,
UD Unit Factor
1.00 Liter
UDU Time Base
60 Seconds